Here, the cationic poly (3-acrylamidepropyl trimethyl ammonium chloride) [p (APTMACl)], anionic poly (2-acrylamido-2methylpropane sulfonic acid) [p (AMPS)], and amphoteric poly (APTMACl-co-AMPS) hydrogels were prepared via free-radical polymerization techniques as pH-sensitive hydrogels. The prepared systems were used in methylene blue (MB), and Eosin Y (EY) removal from aqueous media. HCl-treated p (APTMACl-co-AMPS) hydrogels prepared in 1:3 mol ratio adsorbed higher amount of MB and EY from their corresponding 50 ml 50 ppm aqueous solutions that are 47.5 /- 0.9, and 10.7 /- 0.1 mg/g, respect ...Daha fazlası
Among the various metal ions, chromate (Cr(VI)) and arsenate (As(V)) are the two most hazardous toxic ion species and are found in nature in the form of dichromate and arsenate anions. In this investigation, polyethyleneimine (PEI)-based hydrogels were prepared with microgel, cryogel, and bulkgel morphologies employing glycerol diglycidyl ether as a crosslinker. The prepared PEI-based hydrogels were used to remove dichromate and arsenate anions from aqueous media. PEI microgel, cryogel, and bulkgels weighing 50 mg of each adsorbed 84.7 /- 0.8, 76.5 /- 5.2, and 108.9 /- 2.4 mg.g(-1) of dichroma ...Daha fazlası
The catalytic effects of metal nanoparticles (MNPs) synthesized in sodium bis(2-ethylhexyl) sulfosuccinate (AOT) microemulsion system by using M(II) salts (M = Fe, Co, Ni) and NaBH4 reducing agent on methylene blue (MB) degradation reaction were investigated. It was determined that Co-MNPs gave the best catalytic activity among them. Influence of the reaction parameters e.g., reaction time, temperature, the size of catalyst and the MNP types on the catalytic performance were studied. It was found that 37 /- 6 nm Co-MNPs revealed the best catalytic activity in all studies. The best activation p ...Daha fazlası
To reduce water pollution caused by fertilizers in agricultural irrigation, highly swelling crosslinked hydrogels (p(DMAAm-co-MA) or DM1) based on N,N-dimethylacrylamide (DMAAm) and maleic acid (MA) were prepared using a chemical initiator with the redox polymerization technique. Negative and positive surface modifications of DM1 were achieved using hydrochloric acid (HCl) (p(DMAAm-co-MA)/HCl or DM2) and sodium hydroxide (NaOH) (p(DMAAm-co-MA)/NaOH or DM3), respectively. The synthesized hydrogels were named DM1, DM2 and DM3, respectively. The swelling properties, urea sorption and urea release ...Daha fazlası
At present, titanium dioxide supported cadmium catalysts were prepared at 0.5-5?admium loading by impregnation method. 0.5?d/TiO2 catalyst was characterized with scanning electron microscopy-energy dispersive X-ray (SEM-EDX), X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS). Characterization results revealed that by cadmium doping to titanium dioxide, surface electronic properties and crystal structure of Cd/TiO2 catalysts changed as obtained from SEM-EDX, XRD, and XPS. Following this, methylene blue degradation and electrochemical oxidation measurements were examined under ...Daha fazlası
In this study, magnetic metal nanoparticles (MNP) were prepared by using Fe, Co and Ni ions and NaBH4 as reducing agents in oil-in-water microemulsion system. The prepared MNP were used as catalyst in 4-Nitro phenol (4-NP) reduction to 4-Aminophenol (4-AP). It was found that magnetic Co MNP performed superior catalytic performances than Fe and Ni MNP for 4-NP reduction. The catalytic reduction experiments revealed that as the concentration of reducing agent, NaBH4 that was used in the preparation of Co MNP was increased, the complete conversion time for 4-NP to 4-AP was decreased as the sizes ...Daha fazlası